Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Powertrain Management > PROM - Programmable Read Only Memory > Component Information > Technical Service Bulletins > Campaign - Transmission Control Module Software Upgrade > Page 4130

Page 3
background image

General Description

The reprogramming equipment requires the ECM part number to be entered, and only allows the programming of ECMs. Then the data is downloaded to
the ECM. When the download is completed, the system will check for a successful data transfer. If any errors are detected, the system will permit start of
the programming procedure again.

Programming Operation

1.

Connect the Lap Top

-

Open rear cover from Lap Top PC

-

Connect Lap Top PC (# 1) to the Programmer using the V24-cable.

-

9 pin female connects to the Lap Top PC (# 11).

-

25 pin male connects to the Programmer (# 13).

-

Connect the power supply to the programmer. Use AC/DC converter 120V-12V (# 3)

-

Connect the power supply to the laptop PC. Use AC/DC converter 120V-18.5V (# 5)

Powertrain Management > PROM - Programmable Read Only Memory > Component Information > Technical Service Bulletins > Campaign - Transmission Control Module Software Upgrade > Page 4130

[PREV PAGE] [NEXT PAGE]