Volvo Workshop Manuals
V70 GL L5-2.4L VIN 55 B5254S (1998)
Powertrain Management > PROM - Programmable Read Only Memory > Component Information > Technical Service Bulletins > Campaign - Transmission Control Module Software Upgrade > Page 4133
If using the engine control module (ECM) from another car, diagnostic trouble codes (DTCs) (if any) must be erased and adaptive functions
Reinstall ECM box cover.
To program another ECM
Connect the ECM to the programmer.
Switch on power to the programmer.
Press <Enter>, and the start menu will appear.
Secure that <START> is selected.
Press <Enter>, and follow the instructions on the laptop PC screen.
Repeat steps 3 through 7
Switch off power to the Laptop-PC.
If something goes wrong
The Lap Top PC system checks for a successful data transfer. If any errors are detected, a second programming procedure can be performed. In case of
This part number is located on the label of the ECM. The number starts with 0 261..
If the power supply to the programmer is interrupted during the programming procedure, you can reprogram the ECM by typing "GO" and then
For questions regarding the programming equipment call Bosch Hotline number:
Other questions shall be put forward to your normal field support.
If you are instructed by Bosch to return the kit, please send it to the following address.
The complete reprogramming kit must be returned. A new kit will be sent to you in return.
Robert Bosch Corporation
|[PREV PAGE] [NEXT PAGE]|