Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Relays and Modules > Relays and Modules - Body and Frame > Seat Heater Control Module > Component Information > Technical Service Bulletins > Customer Interest for Seat Heater Control Module: > 3390025 > Jul > 01 > Radio - Interference/Noise On AM Band > Page 96

Page 9
background image

Drill a 5 mm hole in the plate between the clamp for the backrest mounting and the clip for the wire for the seat belt tensioner.

Position the hole approximately 15 mm (0.6 ) from the clip.

Remove any burs.

Install the:

-

ground lead using screw p/n 958244. Route the ground lead along the existing wire through the backrest upholstery

-

cable for the seat belt tensioner in the clip.

16

Installing the backrest cushion

Push the padding and upholstery back into position. Pull the tie strap closed at the inner edge of the backrest upholstery.

Install the:

-

guide for the inner mounting for the cushion

-

inner half moon clip and ring for the strap for the seat belt

-

remaining half moon clips

-

backrest (1). Tighten to 48 Nm (35 lbf.ft).

Connect the seat belt tensioner connector.

Install the strap for the seat belt buckle.

Relays and Modules > Relays and Modules - Body and Frame > Seat Heater Control Module > Component Information > Technical Service Bulletins > Customer Interest for Seat Heater Control Module: > 3390025 > Jul > 01 > Radio - Interference/Noise On AM Band > Page 96

[PREV PAGE] [NEXT PAGE]