Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Page 810

Page 3
background image

Wrench 999 5486

-

Pull fuel level sensor cable out through the hole by the fuel level sensor.

-

Remove the plastic fuel level sensor collar. Use tool 999 5486-9.

-

Lift up the fuel level sensor.

-

Remove gasket.

CAUTION:  Reinstall the collar, otherwise the pipe sleeve may swell making the collar hard to reinstall.

DDL8 Installing Fuel Level Sensor:

-

Use a new rubber gasket.

-

Lubricate the inside and top of the rubber gasket with petroleum jelly.

-

Install gasket on fuel tank sleeve.

-

Install fuel level sensor with electrical connections along the car.

-

Tighten nut to 30 Nm (22.1 ft.lb).

-

Turn fuel level sensor cables to the left and thread them through the hole by the fuel pump (FP).

-

Put all cables together in the protective tube. Wind insulating tape around the protective tube.

-

Connect fuel level sensor.

-

Reinstall covers, hatches and cargo compartment carpet in reverse order. Check that no cables are trapped.

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Page 810

[PREV PAGE] [NEXT PAGE]