Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Ignition Switch: > 3330002 > May > 98 > Campaign - Starter/Ignition Switch Replacement > Page 1208

Page 2
background image

Release the lock for the tilt/telescope adjustment and pull the steering wheel toward the rear of the vehicle and lock the wheel in this position.

Remove the steering column covers.

Removing electrical components

2

Carefully separate the connector from the starter switch.

Remove the two screws that holds the starter switch to the ignition lock.

Carefully remove the starter switch from the ignition lock.

Installing ignition switch

3

Before installing the starter switch; make sure that the center key hole in the starter switch is properly aligned with its corresponding dowl key in the
ignition lock. Reconnect the wiring connector to the ignition switch.

Reinstalling panel and steering wheel covers.

4

Caution!

Route the wire harness for the starter switch so that no schafing and/or pinching can occur when reinstalling the steering column covers.

Reinstall column covers.
Reconnect battery.
Set radio code.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Ignition Switch: > 3330002 > May > 98 > Campaign - Starter/Ignition Switch Replacement > Page 1208

[PREV PAGE] [NEXT PAGE]