Volvo Workshop Manuals
V70 GL L5-2.4L VIN 55 B5254S (1998)
Starting and Charging > Sensors and Switches - Starting and Charging > Ignition Switch > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Ignition Switch: > 3330002 > May > 98 > Campaign - Starter/Ignition Switch Replacement > Page 5416
Release the lock for the tilt/telescope adjustment and pull the steering wheel toward the rear of the vehicle and lock the wheel in this position.
Remove the steering column covers.
Removing electrical components
Carefully separate the connector from the starter switch.
Remove the two screws that holds the starter switch to the ignition lock.
Carefully remove the starter switch from the ignition lock.
Installing ignition switch
Before installing the starter switch; make sure that the center key hole in the starter switch is properly aligned with its corresponding dowl key in the
Reinstalling panel and steering wheel covers.
Route the wire harness for the starter switch so that no schafing and/or pinching can occur when reinstalling the steering column covers.
Reinstall column covers.
|[PREV PAGE] [NEXT PAGE]|