Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Axle Shaft > Component Information > Service and Repair > Axle Shaft Assembly, Constant Velocity Type > Page 4588

Page 3
background image

6. LH driveshaft:

-

Remove driveshaft from transmission.

Use prying tool No. 999 5462, or equivalent, to apply leverage between transmission and inside of driveshaft.

NOTE:  Take care not to damage driveshaft seal or boot (gaiter).

Installation

Special Tools

-

Counterhold Tool No. 999 5461, or equivalent

-

Counterhold Tool No. 999 5540, or equivalent

-

Torque Sleeve Tool No. 115 8147-7, or equivalent

Universal Tool

-

Protractor tool No. 951 2050, or equivalent

NOTE:  The Procedure is the same for both LH and RH driveshafts unless stated otherwise.

Preparation

-

Check that ABS sensor and sensor wheel are free of dirt.

Procedure

1. Install driveshaft to transmission.

NOTE:  Take care not to damage driveshaft seal or boots (gaiter). 

RH Driveshaft:
-

Install bearing cap.

Tighten to: 25 Nm.

-

Install splashguard under engine (earlier models only).

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Axle Shaft > Component Information > Service and Repair > Axle Shaft Assembly, Constant Velocity Type > Page 4588

[PREV PAGE] [NEXT PAGE]