Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Constant Velocity Joint > Component Information > Service and Repair > Page 4602

Page 3
background image

5. Remove balls

-

Tilt inner race and cage and remove balls clockwise, one by one.
Use an electric scriber to mark where you started removing the balls.

-

Put the balls in order so they can be put back in the same position later.

6. Remove cage and inner ring from shaft. 

-

Rotate inner race 90° relative to cage. 

-

Remove inner race. 

-

Remove circlip from inner race.

7. Clean all CV joint components thoroughly.

If any part shows signs of cracking or scoring, replace entire CV assembly

NOTE:  Slight scoring or pitting in races is acceptable.

8. Installing inner race in cage. 

-

Line up markings and put the first ball in.

NOTE:  Carefully note positions of balls.

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Constant Velocity Joint > Component Information > Service and Repair > Page 4602

[PREV PAGE] [NEXT PAGE]