Volvo Workshop Manuals
V70 GL L5-2.4L VIN 55 B5254S (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Constant Velocity Joint Boot > Component Information > Service and Repair > Page 4608
5. Remove balls
Tilt inner race and cage and remove balls clockwise, one by one.
Put the balls in order so they can be put back in the same position later.
6. Remove cage and inner ring from shaft.
Rotate inner race 90° relative to cage.
Remove inner race.
Remove circlip from inner race.
7. Clean all CV joint components thoroughly.
If any part shows signs of cracking or scoring, replace entire CV assembly
NOTE: Slight scoring or pitting in races is acceptable.
8. Installing inner race in cage.
Line up markings and put the first ball in.
NOTE: Carefully note positions of balls.
|[PREV PAGE] [NEXT PAGE]|