Volvo Workshop Manuals
V70 GL L5-2.4L VIN 55 B5254S (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Wheel Bearing > Component Information > Service and Repair > Front > Page 4630
Detach the drive shaft from where it was placed earlier.
Note! Take care not to damage the brake hose.
Install the drive shaft in the hub by hand, but only to the extent that the drive shaft can easily move backward and forward in its position
Clean off any rust from the ball joint and stub axle.
Note! Press the ball joint upwards so that the conical top is visible above the screwed joint on the stub axle.
Install the screw and a new nut.
|[PREV PAGE] [NEXT PAGE]|