Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Wheel Bearing > Component Information > Service and Repair > Front > Page 4632

Page 9
background image

Clean and check that the ABS sensor mating surface on the stub axle is flat.
Apply a very small amount of grease to the mating surface.
Install the ABS sensor cable in the holder on the spring strut.
Install the ABS sensor. Lubricate the screw and tighten to 10 Nm (7.4 ft. lbs.). 

Install the wheel
Install the wheel studs lightly. Then tighten them crosswise to 110 Nm. 

Note!  See also wheels and hubs, front suspension.

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Wheel Bearing > Component Information > Service and Repair > Front > Page 4632

[PREV PAGE] [NEXT PAGE]