Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 2106
Crankshaft Main Bearing Seal: Service and Repair
Handle tool No. 999 1801, or equivalent
Gear Sector tool No. 999 5112, or equivalent
Driver tool No. 999 5430, or equivalent
NOTE: For additional information on special tools and equipment used in this procedure, refer to Service and Repair. See: Tools and Equipment/Tools
NOTE: Proceed with transmission removed as described under Transmission Removal, refer to Transmission and Drivetrain.
1. Remove flywheel/drive plate:
Use gear sector 999 5112, or equivalent.
2. Replace seal:
Remove seal using a groove-cut chisel.
NOTE: Do not damage contact surfaces. Note the position of seal in relation to sealing flange.
Oil seal contact lip.
Install seal using driver tool No. 999 5430 and handle tool No. 999 1801, or equivalents.
Knock in seal until the driver hits the crankshaft.
3. Reinstall flywheel/carrier plate:
Use gear sector tool No. 999 5112, and special screws tool No. 999 5593, or equivalents.
Reinstall the flywheel using the three special screws and tighten (diagonally) to: 45 Nm (33 ft lb)
|[PREV PAGE] [NEXT PAGE]|