![]() |
Volvo Workshop Manuals | |
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Air Flow Meter/Sensor > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Air Flow Meter/Sensor: > 2230010 > Apr > 98 > Mass Air Flow Sensor - Rerouting Wiring Harness > Page 2653![]() Slacken off the two nuts holding the fusebox bracket a few turns. Press the fusebox backward and towards the left side of the car. Tighten nuts to 25 Nm (18.4 ft. lbs). 2 Disconnect connector - Disconnect connector - Disconnect/connect connector 3 times to remove oxide layer on the mating surface. - Check that no terminals have been backed out of the connector and they are undamaged. 3 Lubricate the connector Check terminals if they are greased. Add grease only if it is missing. Use low temperature grease. 0.5 gram/car. Make sure that no dint is introduced with the grease. 4 Secure the cable harness to the mass air flow (MAF) sensor Position cable with an 18 mm (23/32") diameter loop (B), so that it is not putting stress on the connector (check with calipers). Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Air Flow Meter/Sensor > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Air Flow Meter/Sensor: > 2230010 > Apr > 98 > Mass Air Flow Sensor - Rerouting Wiring Harness > Page 2653 | ||
[PREV PAGE] [NEXT PAGE] |