Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Relays and Modules > Relays and Modules - Body and Frame > Seat Heater Control Module > Component Information > Technical Service Bulletins > Customer Interest for Seat Heater Control Module: > 3390025 > Jul > 01 > Radio - Interference/Noise On AM Band > Page 82
Drill a 5 mm hole in the plate between the clamp for the backrest mounting and the clip for the wire for the seat belt tensioner.
Position the hole approximately 15 mm (0.6 ) from the clip.
Remove any burs.
ground lead using screw p/n 958244. Route the ground lead along the existing wire through the backrest upholstery
cable for the seat belt tensioner in the clip.
Installing the backrest cushion
Push the padding and upholstery back into position. Pull the tie strap closed at the inner edge of the backrest upholstery.
guide for the inner mounting for the cushion
inner half moon clip and ring for the strap for the seat belt
remaining half moon clips
backrest (1). Tighten to 48 Nm (35 lbf.ft).
Connect the seat belt tensioner connector.
Install the strap for the seat belt buckle.
|[PREV PAGE] [NEXT PAGE]|