Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Transmission and Drivetrain > Automatic Transmission/Transaxle > Actuators and Solenoids - A/T > Shift Solenoid, A/T > Component Information > Service and Repair > Shift Solenoid Inspection/Replacement > Page 4525
Shift Solenoid: Service and Repair
Lifting frame tool No. 999 5006, or equivalent
Support rails tool No. 999 5033, or equivalent
Lifting hook tool No. 999 5460, or equivalent
Separator tool No. 999 5477, or equivalent
Protective Sleeve tool No. 999 5562, or equivalent
Mobile Jack tool No. 998 5972, or equivalent
Tool No. 998 8670, or equivalent
Protractor tool No. 951 2050, or equivalent
Refer to special tool section for additional tool information. See: Tools and Equipment
Refer to steps 1 through 14 of Open The Control System. See: Valve Body/Service and Repair
Inspection/Replacement Of Wiring Harness
ACL complete with inlet pipe.
Disconnect transmission connector.
Remember rubber seal.
3. Checking of wiring harness
Use ohmmeter to measure resistance between transmission connector and end of appropriate solenoid cable.
Shake harness gently during measurement to locate possible loose connections.
Connector Pin/Wire Color Codes
Pin No: 21
Pin No: 22
Pin No: 23
Pin No: 24
Pin No: 25
Solenoid/Color: STH, ground/blue
|[PREV PAGE] [NEXT PAGE]|