Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 4
background image

8. Install:

-

Retainer to cable harness grommet.

-

Gear position sensor bracket screw.

-

Selector lever.

Tighten to: 16 Nm.

-

Gear selector cable with washer and retaining clip.

Apply grease part No. 1161241-3, or equivalent, sparingly to lever arm pin.

9. Reinstallation of connector.

-

Reinstall sockets to connector.

-

Reconnect connector halves.

-

Ensure that rubber sleeve is in position.

-

Secure harness and rubber sleeve with cable ties.

-

Reinstall connector on transmission.

-

Reconnect connector.

-

Remember rubber seal.

10. Finishing work

-

Install control system.

Refer to steps 22 through 38 of Open The Control System. See: 

Transmission and Drivetrain > Automatic Transmission/Transaxle > Valve Body, A/T > Component Information > Service and Repair > Open The Control System > Page 4849

< PREV PAGE NEXT PAGE >