Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Constant Velocity Joint > Component Information > Service and Repair > Front > Page 5023
Turn inner race and cage.
Put balls back in their original positions, one by one.
9. Grease CV joint thoroughly.
Insert a new circlip in the joint's inner race.
Part No. 1161428-6 (80g) (non-turbo models), or equivalent
10. Install new boot on driveshaft.
Fix the driveshaft in a vice.
Install CV Joint on shaft.
Check that inner race sits square inside the joint.
Tap Joint onto shaft using a plastic mallet.
Check that circlip is sitting properly in its groove.
11. Apply remaining grease to inner race and cage.
NOTE: Take care not to get any grease on the parts of the boot (gaiter) which come into contact with CV joints or shaft.
Wipe off any excess grease with methylated (mineral) spirits.
Use pliers tool No. 981 4215, or equivalent.
|[PREV PAGE] [NEXT PAGE]|