V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Install new TCM.
Read off any DTCs set and then clear them.
4. Adaptation of the throttle position TP signal
The TP signal must be adapted whenever a new control module is installed.
Proceed as follows:
Block all four wheels
NOTE: Apply parking brake and press down hard on the brake pedal with left foot during the entire procedure.
Set gearshift selector to position D
Fully depress the Accelerator Pedal (AP) so the kickdown switch closes.
Keep the AP fully depressed for 5 seconds
Release the AP and set the gearshift selector to position P.
The TP signal is now adapted to the new TCM.