volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 9
background image

Installing Propeller Shaft To Bevel Gear 

-

Install propeller shaft according to marking on bevel gear flange

-

Use new screws.

-

Tighten screws crosswise to 8 Nm (5.9 ft.lb.). Then crosswise to 30 Nm (22.1 ft.lb.). Start tightening with the same screw both times. Use
counterhold 999 5561. 

Transmission and Drivetrain > Transfer Case > Seals and Gaskets, Transfer Case > System Information > Service and Repair > Sealing Ring Crown Wheel Shaft Left Hand Side, Replacing > Page 5248

< PREV PAGE NEXT PAGE >