volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 2
background image

-

Install new TCM.

-

Ignition ON.

-

Read off any DTCs set and then clear them.

4. Adaptation of the throttle position TP signal

-

The TP signal must be adapted whenever a new control module is installed.

-

Proceed as follows:

Block all four wheels
Start engine.

NOTE:  Apply parking brake and press down hard on the brake pedal with left foot during the entire procedure.

Set gearshift selector to position D
Fully depress the Accelerator Pedal (AP) so the kickdown switch closes.
Keep the AP fully depressed for 5 seconds
Release the AP and set the gearshift selector to position P.
The TP signal is now adapted to the new TCM.

Transmission and Drivetrain > Transmission Control Systems > Relays and Modules - Transmission and Drivetrain > Relays and Modules - A/T > Control Module, A/T > Component Information > Application and ID > Page 5304

< PREV PAGE NEXT PAGE >