V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Holders marked with 1 (for sensors with angled connector) are located furthest in on the bumper.
Note! On the XC70 the inner sensor holders are located on the skid plate.
-
Holders marked with 2 (for sensors with straight connector) are located furthest out on the bumper.
-
Check for correct location by fitting a sensor in each holder. The inner connectors must be turned to the right.
Illustration C
-
Remove the protective film from the pieces of tape on the sensor holders.
-
Install the sensor holders with the number marking pointing upwards. The top edge of the sensor holders must be horizontal to the bumper.
Note! The tape adheres immediately.
Note! Incorrect positioning of the sensors may result in partial or complete malfunction.
Installing the skid plate (applies to the XC70)
Illustration A