V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Remove the screws (1). Remove the bracket (2).
The bracket shall not be re-used.
Illustration A
-
Install masking tape on the outside of the bumper to avoid damage from the base of the saw.
-
Leave the masking tape in place throughout the installation procedure.
-
Cut along the inside of the flange (1), on the underside of the bumper so that the flange remains in the bumper.
-
After cutting, smooth off the edges using a file.
Only applies if the car is equipped with mouldings
-
In addition, cut out the moulding in accordance with the markings (2).
Illustration B only applies to the V70R up to and including model year 2004
-
Apply masking tape on the outside of the exhaust pipe clip to avoid damage from the saw. Leave the masking tape in place during installation.
-
Cut along the marked raised area and remove the cut-out area.
-
After cutting, smooth off the edges using a file.
-
Clean away any underseal and dirt from the surfaces between the tow hitch and the bodywork.