V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Connect the cables from the front intake (1), in-vehicle outlet (3) and engine heater (2) to the branch connector
-
Torque the branch connector and bracket on the steering box to 48 Nm (36 lbf.ft.).
Applies to engine heater as illustrated
-
Run the cable from the bumper to the heater cable as illustrated
-
Secure the cable with tie clips using the existing holes and the oil cooler lines
-
Connect the cable from the bumper to the heater cable or to the branch connector.
Note! Cables must not be attached to drive shafts, or to A/C, fuel or brake lines. Ensure that clipped cables are not rubbing against sharp
edges, or are not positioned too close to a turbo or exhaust pipe due to the risk of heat radiation.
-
Fit sealing sleeves over all cable connectors and joints, ensuring that these are correctly located.
-
Refit the air baffles and guard plate as per items 6 and 7
-
Torque screws to 80 Nm (60 lbf.ft.), and screws and nuts to 60 Nm (43 lbf.ft.)
-
Secure the servo hose to the cross strut using a tie clip from the kit.