V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
the brake pads.
Drain any remaining brake fluid.
Note: Do not depress the brake pedal while the brake pads are removed.
Install the brake pads and brake caliper
the brake hose (4) in the brake caliper. Do not tighten the hose yet
the brake pads
the brake caliper.
Install the locating pins (2) in the brake caliper
Check the rubber sleeves of the locating pins. Replace if necessary.
Lubricate the locating pins using grease, P/N 1161325-4.
Insert the locating pins into the rubber sleeves. The pins should slide into the sleeves easily.
Tighten the locating pins to 30 Nm. Install the protective caps (1) and the securing spring (3).
Tighten the brake hose in the caliper. Tighten to 18 Nm
Check the brake hose
Ensure that the brake hose is not twisted. If necessary alter the hose at the other end (brake pipe end).
Note: If the brake hose is twisted it may rub against the tire, rim or wheel arch. This could cause the circuit to fail.
Fill and bleed the brake system
Replacing the front brake calipers.
Install the wheel