V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Connect drain bottle hose. Open nipple approx. one turn.
- Push brake caliper piston to bottom of caliper using a bolt clamp. Leave bolt clamp in the pushed-in position.
- Pressurize braking system with bleeding unit. Drain off 2 - 3 dl (0.2 - 0.3 US qt) brake fluid.
- Close bleed nipple and remove hose.
- Re-fit protective cap.
- Depressurize braking system using the bleeding unit.
- Remove bolt clamp from brake caliper.
- Depress brake pedal a few times.
[CCCC6]
Replacing brake fluid RH, front
- Repeat steps [CCCC3 - CCCC5], on the front RH brake caliper. Then continue as per instructions below.
[CCCC7]
Removing brake pad LH rear
Remove:
- Brake pad from brake caliper as per KB , Service manual, TP 5001011.
[CCCC8]
Replacing brake fluid LH rear
- Remove protective cap from bleed nipple.
- Connect drain bottle hose.
- Open nipple approx. one turn.
- Push brake caliper pistons to bottom of caliper. Use tool 999 2809 (x 2). Leave tools on calipers.
- Pressurize braking system and bleeding unit.
- Drain ~ dl brake fluid
- Close bleed nipple and remove hose.
- Re-fit protective cap.
- Depressurize braking system using bleeding unit.
- Remove tools from brake calipers.
[CCCC9]
Installing rear brake pad
- Install brake pad as per KB , Service manual, TP 5001011.
- Depress brake pedal a few times.
[CCCC10]
Replacing brake fluid RH, rear
- Repeat steps CCCC6 - CCCC8, on RH rear brake caliper.