V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
-
Install drain hose to floor.
-
Install knee bolster, if necessary.
-
Install the RTI (road traffic information) member with its mounting on the cowl side on passenger side.
-
Install the RTI or amplifier bracket.
-
Fold forward the bracket on the passenger side and screw into place.
-
Install the floor duct pipes.
-
Install the cable tie straps so that the passenger side floor duct is exposed.
-
Install floor carpet mountings.
-
Connect and install the climate control unit connector.
-
Install the cable harness with tie straps on the air distribution housing.
-
Install the cable harness on the bracket (was relay base).
-
Right-hand drive car:
-
install fresh air intake on the control module box.
-
Install the dashboard, refer to Boday and Frame - Dash Board - Service and Repair - Procedures See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair
-
Install center console
-
Install the electronic climate control (ECC) module See: Control Module HVAC/Service and Repair
-
Install the manual climate control (MCC) module See: Control Assembly/Service and Repair
Work in the engine compartment
-
Install cover plate and rubber seal for heat exchanger lead-in.
-
Install the heater pipes on the heat exchanger.
-
Top up the coolant.
-
Install the holder.
-
Install the pollen filter.
-
Install the gutter, refer to Wiper and Washer Systems - Wiper Motor - Service and Repair - Procedures See: Wiper and Washer
Systems/Wiper Motor/Service and Repair
-
Install windshield wiper, refer to Wiper and Washer Systems - Wiper Arm - Service and Repair - Procedures See: Wiper and Washer
Systems/Wiper Arm/Service and Repair
-
Connect the battery lead.
Additional for cars with air conditioning (A/C):
-
install the cover plate and rubber seal for the evaporator lead-in.
-
install the evaporator pipes
NOTE!
Use new O-rings.
-
install the screw holding the pipe connector and receiver/drier bracket
-
fill system with refrigerant and check for leaks See: Service and Repair
-
Carry out self-adjustment of the damper motors when the work is finished.