Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)

Powertrain Management > Fuel Delivery and Air Induction > Turbocharger > Wastegate Actuator > Component Information > Service and Repair > Page 4217

Page 2
background image

Basic Adjustment of Pushrod

-

Connect manometer 999 5230 and pressure tester 998 5496 to pressure servo.

-

Pump up pressure to 18 ± 1 kPa (2.56 ± 0.14 psi).

-

Push boost pressure control (BPC) valve spindle towards turbocharger (TC) housing (closed valve).

-

Adjust push rod so that it fits onto spindle lug exactly.

-

Install lock pin to boost pressure control (BPC) valve spindle.

-

Tighten pushrod locknut.

-

Remove manometer and pressure tester.

NOTE!  Push rod must not be twisted during adjustment, otherwise pressure servo diaphragm may be damaged.

Reinstall

Install:
-

Hose on turbocharger (TC) control valve.

-

Fresh air intake between turbocharger (TC) and mass air flow (MAF) sensor.

-

Heat deflector plate.

Powertrain Management > Fuel Delivery and Air Induction > Turbocharger > Wastegate Actuator > Component Information > Service and Repair > Page 4217

[PREV PAGE] [NEXT PAGE]