Volvo Workshop Manuals
V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Powertrain Management > Ignition System > Sensors and Switches - Ignition System > Ignition Switch > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Ignition Switch: > 3330002 > May > 98 > Campaign - Starter/Ignition Switch Replacement > Page 4334
Release the lock for the tilt/telescope adjustment and pull the steering wheel toward the rear of the vehicle and lock the wheel in this position.
Remove the steering column covers.
Removing electrical components
Carefully separate the connector from the starter switch.
Remove the two screws that holds the starter switch to the ignition lock.
Carefully remove the starter switch from the ignition lock.
Installing ignition switch
Before installing the starter switch; make sure that the center key hole in the starter switch is properly aligned with its corresponding dowl key in the
Reinstalling panel and steering wheel covers.
Route the wire harness for the starter switch so that no schafing and/or pinching can occur when reinstalling the steering column covers.
Reinstall column covers.
|[PREV PAGE] [NEXT PAGE]|