V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Inspect SIPS-bag system
Inspect firing circuit
-
Make a visual inspection of the exposed portion of the firing circuit on the seat.
If there is visible damage to the firing tube's protective sleeve:
-
Remove sleeve and make sure that firing tubes are not damaged.
Inspect sensor unit
-
Remove sensor unit.
-
Remove transport safety device from sensor unit.
WARNING: Use caution when SIPS bag is unlocked! Do not exert any external pressure on sensor unit. Aluminum cover on sensor unit
must not be pressed in or dented.
It should be easy to remove the sensor unit from and install it into the SIPS tube. If sensor unit is wedged in or difficult to remove, it may be dented.
-
Measure sensor unit height according to drawing.
Height must not be less than 27.0 mm (1.06 inches).
-
Install transport safety device on sensor unit.
If SIPS bag is OK:
Install in opposite order.
If any SIPS bag components are damaged:
Replace with a complete new SIPS bag.