Volvo Workshop Manuals
V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Fuel Sending Unit - Installation > Page 807
Remove the sending unit with the gasket.
Install new fuel sending unit
The mark (arrow) on the sending unit must be pointing within the marks on the tape.
Install new gasket on sending unit.
Lubricate the top surface of the sending unit to avoid twisting while tightening the retaining nut. Use petroleum jelly or equivalent.
Carefully insert the new sending unit into the tank.
Alignment of the sending unit
Align the sending unit as per illustration.
Install the retaining nut and torque to 30 Nm (22 ft. lbs).
|[PREV PAGE] [NEXT PAGE]|