Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Knock Sensor > Component Information > Diagrams > Page 1292

Page 3
background image

Installing Intake Manifold

Install:
-

New gasket with four lower manifold screws.

-

Intake manifold.

Note!  Ensure that crankcase ventilation hose is not trapped between cylinder head and intake manifold when tightening.

-

Three upper intake manifold screws.

Tighten all screws to 20 Nm (14.76 ft.Ib).

-

Support bracket.

-

Dipstick.

Installing Fuel Rail

Install:
-

Pipe from pressure regulator.

-

Fuel rail and two fuel line clamps, press clip holding the pipe from the pressure regulator into place.

-

New screws and tighten.

Tightening torques 10 Nm (7.38 ft.lb).

-

Remove injector holders.

-

Injector connectors. Check that each connector is fitted with a rubber seal.

-

Injector cable harness clip.

-

Fuel rail cover.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Knock Sensor > Component Information > Diagrams > Page 1292

[PREV PAGE] [NEXT PAGE]