V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Install the mounting nut
Tighten it to 70 Nm (51.6 ft. lbs.). Use socket 999 5469 and counterhold 999 5468.
Install:
-
the spring strut mounting
-
washer and nut. Tighten the nut to 70 Nm (51 6 ft. lbs.).
Use socket 999 5467 and counterhold 999 5468.
Remove the spring clamps
Installation
Install the spring strut in the bodywork with the new nuts
Tighten the three spring strut mounting nuts to 25 Nm (18.44 ft. lbs.).
1994 model year cars
On 1994 model year cars, the size of the holes in the stub axles for the shock absorber mounting screws has increased from 12.1 mm (0.47 inch) to 13
mm (0.51 inch) diameter.
Note! Stub axles with 13 mm (0.51 inch) diameter mounting holes are also introduced as replacement part and replace the earlier version.
When replacing shock absorbers on cars with the new stub axles, two sleeves, P/N 9153007-1 should be installed. The sleeves should be installed in
the stub axle screw holes, see illustration. This removes play between the screws and the holes and the correct camber angle is retained.
Note! The screws can be stiff in the holes.
Install spring strut to the stub axle
