V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
18. Solenoid SL
Solenoid SL is in two variants:
Early types with the connection to the cable harness from the right
Later types with the connection from the left.
Early version and replacement parts
Solenoid SL is only available in the early version as a replacement part
19. Checking resistance
Solenoids S1, S2, SL:
Measure resistance between pin in solenoid connector and transmission ground terminal.
The correct resistance should be: 10-15 ohms
Measure resistance between pins in solenoid connector.
The correct resistance should be: 2-6 ohms
20. If solenoid resistances are correct:
Perform preparations as per step 2 of Solenoid Wire Harness Inspection/Replacement. See: Valve Body/Service and Repair
Check wiring harness between solenoids and-connector on transmission as per step 3 of Solenoid Wire Harness Inspection/Replacement. See:
Valve Body/Service and Repair.
If solenoid S1, S2 or SL value is incorrect:
Replace solenoid as outlined in the following steps.
If solenoid STH value is incorrect:
Replace complete control system as per step 2 of Control System Replacement. See: Valve Body/Service and Repair
(Solenoid STH is calibrated together with the control system).