V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
6. Installing circlip and sleeve
Circlip in sleeve
Sleeve in transmission with the long splined section (2) toward the transmission.
Use a rubber mallet to knock in the sleeve.
NOTE: To install bevel gear and drive shaft, see steps 8 through 15 of Bevel Gear, Replacement. See: Transfer Case/Service and Repair
Standard Handle tool No. 999 1801, or equivalent
Lifting Beam tool No. 999 5006, or equivalent
Lifting Hook tool No. 999 5460, or equivalent
Disconnecting tool No. 999 5462, or equivalent
Drift tool No. 999 5541, or equivalent
Protective Sleeve tool No. 999 5562, or equivalent
Support tool No. 999 5563, or equivalent
1. Positioning lifting beam and lifting hook
Position lifting beam 999 5006 directly above lifting hole in torque control arm.
Connect lifting hook 999 5460.
Raise lifting hook to unload engine pads.
2. Lift up car and remove left front wheel
The bracket to the brake pipe and ABS line. Let bracket hang loose
Link from anti-roll bar
Control arm/ball joint from stub axle.