V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
7. Install engine mounting to transmission and subframe
-
Tighten screws to 50 Nm (36.9 ft lb).
8. Install drive shaft
-
Press the drive shaft in firmly so that it locks on to the differential gear.
Ensure that the drive shaft lock ring sits in its locking groove.
Check by pulling carefully on the drive shaft constant velocity joint.
NOTE: Ensure that the drive shaft boot and the transmission sealing ring are not damaged
9. Remove control arm depressor
-
Remove depressor 999 5563 on control arm.
-
Install:
Control arm/ball joint to axle shaft.
Remove socket 999 5562 from ball-joint.
Use a new locknut, tighten to 50 Nm (36.9 ft lb)
Anti-roll bar link.
Use a new locknut, tighten to 50 Nm (36.9 ft lb)
The bracket to the brake pipe and ABS line.
-
Install wheel.
-
Remove lifting beam and lifting hook.