V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Installing Flange To Pinion
Install Drive Flange
-
If reinstalling the old flange, install according to markings.
-
Use press tool 999 5504. Use a new, lubricated nut. There must be no axial play.
NOTE: If installing a new flange, measure according to Measuring flange, viscous coupling and Balancing procedure. Refer to Drive/Propeller
Shafts, Bearings and Joints. See: Drive/Propeller Shafts, Bearings and Joints/Service and Repair
-
Tighten to 180-200 Nm (132.8-147.6 ft.lb.). Use counter- hold 999 5652.
NOTE: Do not exceed a tightening torque of 200 Nm (147.5 ft.lb.). The forces on the pinion bearing may become too great, causing it to seize.
-
If reinstalling the old flange, continue with installing viscous coupling.