V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Support - Half Shaft/Short Shaft: Service and Repair
Standard shaft tool No. 999 1801, or equivalent
Ring tool No. 999 2853, or equivalent
Drift tool No. 999 5118, or equivalent
Press ring tool No. 999 5491, or equivalent
Drift tool No. 999 5318, or equivalent
Drift tool No. 999 5519, or equivalent
Refer to special tool section for additional tool information.
Pliers tool No. 981 4215, Or Equivalent
Removing/replacing driveshafts, see:
Axle Shaft Assembly, Constant Velocity Type, Removal steps 1 through 6. See: Axle Shaft/Service and Repair/Front/Removal
Axle Shaft Assembly, Constant Velocity Type, Installation steps 1 through 4. See: Axle Shaft/Service and Repair/Front/Installation
Unless stated otherwise, the Procedure for replacing the support bearing and cleaning the inboard universal joint is the same for both manual and
The inboard universal joint can only be dismantled in automatic models.
Driveshaft, manual models,
1. Exposing inboard universal joint
Remove clips from inboard boot (gaiter).
Slide boot (gaiter) off inboard universal joint.
2. Cleaning off grease from universal joint.
Mount driveshaft In vice with gap In circlip pointing upwards.