V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Wiper Motor Linkage: Adjustments
CA11 Method if Link Arms are Out of Position:
-
Remove wiper unit according to CA1 - CA6. See: Wiper Motor/Service and Repair
-
Slacken off nut to the crank link on the wiper motor spindle.
-
Adjust position of crank link so that it is parallel with the longer spindle.
-
Press down the crank link onto the motor spindle splines. Apply thread sealant P/N 1161053-2 to the motor spindle thread.
-
Tighten nut to 20 Nm (14.8 ft.lbs). Use a 20 mm (0.79 in) fixed wrench as a counterhold on the crank link when tightening the nut.
-
Install wiper unit according to CA7 - CA10. See: Wiper Motor/Service and Repair
Carry out a function test and adjust if necessary until the unit is operating satisfactorily.