V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Slacken the off brake hose approximately half a turn.
Remove the screws holding brake caliper.
Unscrew the brake caliper from the brake hose.
Drain the remaining brake fluid.
Installation
Note! For tightening torques, see Tightening torque See: Specifications/Tightening Torque.
Installing the brake caliper and brake pads
Thread the brake caliper onto the brake hose. Do not tighten.
Install the screws for the brake caliper.
Tighten the brake hose.
For tightening torques, see Tightening torque See: Specifications/Tightening Torque.
Note! The brake hose must not be twisted. If necessary alter the hose at the other end (brake pipe end).
Install the brake pads. See Brake pad, replacing See: Disc Brake System/Brake Pad/Service and Repair/Brake Pad, Replacing.
Bleeding brake systems
Fill and bleed the brake system.
Note! Use only Volvo Genuine parts brake fluid (Volvo DOT 4+).
To bleed the brake system, see Brake system, bleeding (using bleeding unit) See: Brake Bleeding/Service and Repair/Brake System, Bleeding (Using
Bleeding Unit).
Finishing
Check:
-
the function of the brakes after bleeding. Check that there is no leakage
-
brake fluid level.
Depress the brake pedal a few times.