V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Check that the indicator on the belt tensioner is within the marked position.
Remove the upper timing cover.
Installing components
Install:
-
the trigger wheel. Tighten the screw
-
the camshaft position (CMP) sensor housing. Tighten the screws
-
the lower and upper torque rod bracket on the cylinder head. Tighten. See Tightening torque See: Specifications/Mechanical
Specifications/Tightening Torque
Install:
-
the front timing belt cover
-
the cover over the ignition coils
-
the upper timing belt cover
-
the auxiliaries belt
-
the expansion tank
-
the power steering fluid reservoir. Check that the hoses are correctly positioned
-
the starter motor. Tighten the screws at the gearbox unit. See Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.
Install:
-
the intake air hose between the turbocharger (TC) and the air cleaner (ACL) cover
-
air cleaner (ACL) assembly
-
the intake pipe between the air cleaner (ACL) and the front cover plate
-
the charge air pipe above the engine. Remove the seals
-
the engine stabiliser brace
-
the cable to the battery negative terminal.
First read Battery, disconnecting See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting.
Checking the engine
Test drive the car to check the function of the engine.
Rear camshaft seal