V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Lubricate the surface of the seal that the camshaft rotates against.
Install the camshaft seal. Use drift 999 5718 Drift See: Tools and Equipment/999 5718 Drift. Use the mounting screws for the variable valve timing unit.
Tighten until the drift bottoms out.
Installing the crankshaft adjustment tool
Remove the starter motor mounting screws.
Pull out the starter motor and put to one side.
Remove the blind cover plug from the hole for the adjustment tool.
Turn the crankshaft clockwise slightly.
Install adjustment tool 999 5451 ADJUSTMENT TOOL See: Tools and Equipment/999 5451 Adjustment Tool. Ensure that the tool bottoms out against
the engine block.
Aligning the crankshaft
Turn the crankshaft counter-clockwise until it stops against the adjustment tool.
Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.
Installing the variable valve timing (VVT) unit on the exhaust camshaft
Note! The purpose of the "Installing the VVT unit/timing gear pulley" section described here is to ensure that the VVT unit is correctly