V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Install:
-
the tie strap under the protective sheath
Note: Secure the tie strap on the smooth central section of the corrugated hose.
-
the protective sheath
-
four tie straps around the protective sheath, hoses and wiring. Secure the tie straps on the four smooth central sections of the corrugated hose.
Installing the right-hand level sensor and pump and the left-hand level sensor in the fuel tank
-
Install the wire on the new ejector for the level sensor and pump
-
Insert the hoses and wiring into the tank via the right-hand tank hole
-
Grip the right-hand level sensor and pump holder and pinch it so that the float is held in its lowest position
-
Carefully and slowly lower the holder. Carefully work the holder into place
-
Pull the wire so that the hoses and wiring end up on the left side of the tank
-
Install the left-hand level sensor on the ejector
-
Install the switches on the underneath of the left-hand level sensor
-
Remove the wire from the ejector.
Finishing
-
Install the sensor, backrest, side cushion and seat cushion. See Draining the fuel tank.