Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V90 L6-2.9L VIN 96 B6304S (1998)

Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Control Module HVAC: > 887955 > Sep > 97 > A/C - Unpleasent Odor On Startup > Page 129

Page 20
background image

Installing new relay on cable harness
-

Take out cable harness (P/N 9162426) supplied with kit

-

Install relay supplied in the 5-pin connector.

E3
Route cables to engine compartment

-

Route green cables with single round or flat terminals to engine compartment through unused outlet in grommet under brace to suspension strut.

-

Connect round or flat connectors to corresponding existing connectors.

-

Connect unconnected connectors.

E4
Location of opening in cable sheath
The cable sheath is cut to drain off condensation.

-

The cut conduit section should be placed at the lowest point along the route of the cable.

-

Use butyl tape to seal the grommet.

-

Use existing cable tie to clamp cables to firewall.

Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Control Module HVAC: > 887955 > Sep > 97 > A/C - Unpleasent Odor On Startup > Page 129

[PREV PAGE] [NEXT PAGE]