Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V90 L6-2.9L VIN 96 B6304S (1998)

Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Control Module HVAC: > 887955 > Sep > 97 > A/C - Unpleasent Odor On Startup > Page 133

Page 24
background image

F3
Route cables to engine compartment
-

Route the cables which do not have connectors to the engine compartment through an unused hole in the grommet under the brace to the suspension
strut.

-

Connect green-red cable to connector terminal 1.

-

Connect green cable to connector terminal 2.

F4

-

Separate existing connectors at the boost pressure switch and connect connector from the new cable harness.

F5
Location of cable sheath opening
The cable sheath is cut to drain off condensation.
-

The cut conduit section should be placed at the lowest point along the route of the cable.

-

Use butyl tape to seal the grommet.

-

Use existing cable tie to clamp cables to firewall.

Connecting cable harness in passenger compartment

Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Control Module HVAC: > 887955 > Sep > 97 > A/C - Unpleasent Odor On Startup > Page 133

[PREV PAGE] [NEXT PAGE]