Volvo Workshop Manuals
V90 L6-2.9L VIN 96 B6304S (1998)
Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Control Module HVAC: > 887955 > Sep > 97 > A/C - Unpleasent Odor On Startup > Page 136
Install control module on front of air hose under glove compartment with butyl tape and cable ties round duct and control module as illustrated.
Locate cable harness with relays between air hose and knee bolster.
Prevent condensation dropping onto relays by ensuring that they are not placed beneath the air hose.
Fasten to air hose with cable ties.
Installing control module from kit.
Connect battery lead and start car.
Turn on A/C system to start compressor. The A/C system starts if the temperature exceeds approx. 7°C (45°F).
Make up a cable (about 2 meters in length) to connect battery positive terminal to the connector on the control module. Connect to green cable,
Turn off engine.
Airing cycle should begin after approximately 10 seconds and continue for approximately 1 second.
Remove cable between connector and battery.
Reinstall all components removed.
Reset the clock and enter the anti-theft radio code if required.
Installing Control Module/Cable 940 W/ECC 1996-
Installing control module and cables
|[PREV PAGE] [NEXT PAGE]|