XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Place the two large connectors for the cable harness where the two 32-pin connectors were previously disconnected from each other.
-
Route the thin ground cable (1) in the mat joint in the same direction as cable harness B to the control module.
Note! Ensure that the cables do not come into contact with moving parts in the tunnel console and that they are not at risk of being cut.
Illustration B
Only applies to left-hand drive vehicles.
-
Route through the thicker cable (2) to the display through the tunnel console in front of the air ducts and out the other side. Use a wire to route the
cables through, if necessary.
Routing the ground cable in cable harness C, continued
-
Route the ground cable the same way as cable harness B, up to the control module.
-
Press the B pillar panel into place again.
Note! Ensure that the ground cable is routed so that it is not at risk of being trapped or cut by sharp edges or similar.