XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Secure the cable using wide pieces of silver or woven tape along the rear crossmember and to the floor.
Note! The ground lead must only be taped at the rear crossmember, it must not be secured by the thick cable harness.
-
Connect the ground lead's ring cable terminal to the ground terminal closest to the spare wheel well.
-
Tighten the ground screw to 10 Nm (7.5 lbf.ft).
Applies to left-hand drive cars
Illustrations A and B
Routing cable harness B/cable harness C
-
Insert the wire into the centre console, up towards the compartment above the air outlet and out through the hole on the right-hand side in the
compartment where the display is to be positioned.
-
Tape the connector and a piece of the cable at the wire spring.
-
Route the cable(s) on the right-hand side in the compartment where the media player was located.
-
Pull the cable(s) forward.