XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Pull up the cable harness from the transformer along the existing wires up under the dashboard, along the collision pipe and on to the lighting
under the dashboard.
-
Secure the cable harness at the thin cable harness using cable ties from the kit, however, do not tighten them yet, adjust the length up to the lighting
in the panel.
Note! Do not clamp the washer hose, and ensure that the cable harness is clamped so that is does not chafe against sharp edges under the
dashboard.
-
Connect the prewired cable harnesses female connector to the courtesy lighting.
-
Connect the two remaining connectors to each other.
-
Now adjust the cable length up to the transformer and tighten the two cable ties.
-
Clamp down loose connectors to existing cable harness under the steering column with cable ties from the kit.
-
Clamp down the connectors at each end of the cable harness so that they do not rattle.