XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Take one of the front cradles from the kit. All cradles are marked and only fit in one place. Always start with the front cradle.
-
Remove the protective tape from the mounting tape.
-
Align the front edge of the cradle with the rear edge of the joint between the sill panels. Ensure that the tape does not adhere yet. At the same time
hook the cradle on the top of the sill panel.
-
Press in the middle of the pieces of mounting tape.
-
Drill out the six marked holes in the cradle using a - 5 mm (13/64") drill bit.
-
Remove the swarf. Use a feeler gauge to remove swarf between the cradle and sill panel.
