XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Drill out the six marked holes using a - 5 mm (13/64") drill bit.
-
Remove the swarf. Use a feeler gauge to remove swarf between the cradle and sill panel.
-
Rivet the cradle in all holes at the sill panel.
-
Break off the hooks along the cradle.
Note! Points 10-12, which describe bonding of the sill decor, are carried out to prevent the sill decor from detaching if the lifting table lifting
plates are incorrectly positioned against the door sill panel and not against the intended lifting points at the front and rear edges of the door sill.
Workshop lifts that lift all away along the door sill must be used with care.
-
Clean the marked area in the groove between the mounting hooks on the cradle using isopropanol and wipe dry.
-
Repeat the procedure with the rear cradle's rear end.
